AD202JN OverviewA 38-DIP (0.600, 15.24mm), 11 Leads case is used to package the op amp. Isolation-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tube case. It is estimated that there will be 10 terminations in the next few months. There are a total of 10 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 15V volts. There are 10 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 15mV. It is recommended that this electronic component be mounted using the Through Hole mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about 0°C~70°C . An 5mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. On this instrumentation amplifier, there are 2 circuits that are connected together. There are a total of 1 elements in this linear amplifier. The operating supply voltage of the buffer op amp is rated at 15V. I would like to point out that this electrical component is capable of working from a voltage below 16.5V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 13.5V at all times. 2GOhm should be the range of resistance for the linear amplifier.
AD202JN Features10 Pins
supply voltage of 15V
40dB voltage gain
Resistance of 2GOhm
AD202JN ApplicationsThere are a lot of Analog Devices Inc.
AD202JN Instrumentational OP Amps applications.
Addition operation circuits
Subtraction operation circuits
single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
| Lifecycle Status | PRODUCTION (Last Updated: 2 weeks ago) |
| Factory Lead Time | 26 Weeks |
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 38-DIP (0.600, 15.24mm), 11 Leads |
| Number of Pins | 10 |
| Operating Temperature | 0°C~70°C |
| Packaging | Tube |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| ECCN Code | EAR99 |
| Resistance | 2GOhm |
| Terminal Position | DUAL |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Base Part Number | AD202 |
| Pin Count | 10 |
| Operating Supply Voltage | 15V |
| Number of Elements | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 16.5V |
| Min Supply Voltage | 13.5V |
| Operating Supply Current | 5mA |
| Nominal Supply Current | 5mA |
| Max Supply Current | 5mA |
| Amplifier Type | Isolation |
| Common Mode Rejection Ratio | 130 dB |
| Current - Input Bias | 30pA |
| Output Current per Channel | 400μA |
| Input Offset Voltage (Vos) | 15mV |
| Bandwidth | 2 kHz |
| Voltage Gain | 40dB |
| -3db Bandwidth | 2MHz |
| Isolation Voltage | 750V |
| Height | 8.9mm |
| Length | 53.3mm |
| Width | 17.8mm |
| REACH SVHC | No SVHC |
| Radiation Hardening | No |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
AD202JN Datasheet
+8613715157867