TL082ACDT Overview
In the package, you will find a 8-SOIC (0.154, 3.90mm Width)-case to contain the op amp ic. The instrumentation amplifier in this picture is of the J-FET-type. A Cut Tape (CT) case is used for delivering the op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 15V battery. The op amp ic has an array of 8 pins on it. Op amp rates 6mV as input offset voltage. For this electrical component, Surface Mount is the recommended mounting type. According to the manufacturer, this buffer op amp works well at 0°C~70°C , which is a good operating temperature. Using an 1.4mA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 106.02dB for the time being. 2 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 18V. The linear amplifier is packaged by using a TAPE AND REEL axis.
TL082ACDT Features
8 Pins
supply voltage of 15V
106.02dB voltage gain

TL082ACDT Applications
There are a lot of STMicroelectronics
TL082ACDT Instrumentational OP Amps applications.

Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification
Signal filtering
Signal operation
Video computer boards

Lifecycle Status	ACTIVE (Last Updated: 6 months ago)
Factory Lead Time	10 Weeks
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	8-SOIC (0.154, 3.90mm Width)
Number of Pins	8
Operating Temperature	0°C~70°C
Packaging	Cut Tape (CT)
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
ECCN Code	EAR99
Terminal Finish	Matte Tin (Sn) - annealed
Packing Method	TAPE AND REEL
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	15V
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	TL082
Pin Count	8
Operating Supply Voltage	18V
Number of Elements	2
Power Supplies	+-15V
Operating Supply Current	1.4mA
Nominal Supply Current	2.5mA
Power Dissipation	680mW
Output Current	40mA
Slew Rate	16V/μs
Architecture	VOLTAGE-FEEDBACK
Amplifier Type	J-FET
Common Mode Rejection Ratio	80 dB
Current - Input Bias	20pA
Voltage - Supply, Single/Dual (±)	6V~36V ±3V~18V
Output Current per Channel	40mA
Input Offset Voltage (Vos)	6mV
Bandwidth	4MHz
Neg Supply Voltage-Nom (Vsup)	-15V
Unity Gain BW-Nom	4000 kHz
Voltage Gain	106.02dB
Low-Offset	NO
Frequency Compensation	YES
Voltage - Input Offset	3mV
Low-Bias	YES
Input Offset Current-Max (IIO)	0.0001μA
Length	4.9mm
Height Seated (Max)	1.75mm
Radiation Hardening	No
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free