XPDNC2000-01 Overview
MPU Core is the type of module or board that is used in this microcontroller.Microprocessor chip is powered by a processor with a total of DSTni-EX cores in it.It is default for the microcontroller to set the mode to -40°C~85°C.There is a flash size 512KB on the MCU electronics.In this case, the connector type is RJ45.There are two versions of this microcontrollers in the XPort® Direct+™ Series.This is done to make sure that the software is able to run normally and that the RAM size is reduced to 256KB.In this MCU chip, the speed is set to 25MHz.As of right now, 85°C is the maximum operational temperature at this time.Microprocessor should be warmer than -40°C when microprocessor is operating.An Intel XPort Direct+ Core Processor is at the heart of this MCUs.This microcontrollers operates on a 3.3V volt supply which is the voltage of the operating supply.The MCUs has been configured to operate at 200mA supply current, which is the default value.
XPDNC2000-01 Features
Core processor of DSTni-EX
Flash size of 512KB
Speed of 25MHz

XPDNC2000-01 Applications
There are a lot of Lantronix, Inc.
XPDNC2000-01 Microcontroller, Microprocessor, FPGA Modules applications.

Industrial Control
Process Control
Process Monitoring
Healthcare Monitoring
Patient Monitoring
IoT Secure Gateways
Human Machine Interface
Human Machine Control Panel
Home and Building Automation
Thermostat

Factory Lead Time	6 Weeks
Operating Temperature	-40°C~85°C
Series	XPort® Direct+™
Size / Dimension	1.25 x 1.7 31.8mmx43.3mm
Part Status	Active
Moisture Sensitivity Level (MSL)	Not Applicable
Connector Type	RJ45
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Operating Supply Voltage	3.3V
Interface	Serial
Operating Supply Current	200mA
Speed	25MHz
RAM Size	256KB
Core Processor	DSTni-EX
Data Rate	921.6 kbps
Module/Board Type	MPU Core
Flash Size	512KB
Co-Processor	XPort Direct+
Radiation Hardening	No
RoHS Status	ROHS3 Compliant